For old posts/forum, please go here : https://sourceforge.net/p/soplanning/discussion/
Pour l'ancien forum, accédez à cette page : https://sourceforge.net/p/soplanning/discussion/

Acid Silicone Sealant

Post Reply
fish63fi
Posts: 10
Joined: Wed Sep 25, 2019 1:29 am

Acid Silicone Sealant

Post by fish63fi » Wed Sep 25, 2019 1:37 am

Glazing and small aquarium silicone sealant
DESCRIPTION:
1.Single-component, room-temperature curing,acetic
2.Designed for glazing & small aquarium
3.Dry fast
TYPICAL USES:
1.Indoor and outdoor decoration works
2.Small aquarium and glass crafts
Direction for Use
1. Before use, make sure that joint faces are clean, dry and free of contaminants.
2. Cut the can's nozzle at a proper angle, put sealant into a gun, and then press it out at 45 degrees to the surface to be bonded.
3. For our acetic silicone sealant, its skinning time is usually less than 15 minutes, and remember to leave it alone for an hour. Then, it will be fully cured within one week.
APPLICATION INSTRUCTION:
1.Binding and compatibility tests must be done before use.
2.The surface of the glued material must be clean,dry and free from any dust particles, grease and oil.
3.Cut the nozzle at an angle and apply the sealant with a hand or air operated cartridge gun.
PRECAUTIONS:
1.Uncured sealant may irritate eyes, system and skin. In case of eye contract, rinse immediately using plenty of water and seek medical advice.
2.Use only in a good ventilated place. Donnot ingest.
3.Keep out of reach of children.
STORAGE:
Store in a cool and dry place (below 27℃)
BOTTLE WEIGHT:
60g
CONT.NET:
300mlAcid Silicone Sealant
website:http://www.sanvo.net/silicone-sealant/a ... e-sealant/

Post Reply